working temperature

英 [ˈwɜːkɪŋ ˈtemprətʃə(r)] 美 [ˈwɜːrkɪŋ ˈtemprətʃər]

工作温度

电力



双语例句

  1. Experimental results in lowering circuit board working temperature of micro gas chromatograph detector
    降低微型气相色谱仪检测器电路板工作温度的实验结果
  2. The prefabricated parts can also be made. Research on Heat Pipe Working Temperature in Electric Furnace Gas Heat Recovery
    高温热风管道内衬,加热炉内衬等部位,可制成预制构件。电炉烟气余热回收中热管元件工作温度的研究
  3. Research on Heat Pipe Working Temperature in Electric Furnace Gas Heat Recovery
    电炉烟气余热回收中热管元件工作温度的研究
  4. Vibration cylinder pressure sensor is a kind of absolute pressure sensor with many merits such as high precision, stable, wide working temperature, low power, anti-vibration, impact resistance.
    振动筒压力传感器是一种具有测量精度高、稳定性好、工作温度范围宽、低功耗、抗震动、耐冲击等优良性能的绝对压力传感器。
  5. In this thesis an entire mathematical model for working temperature of torpedo thermal power system in steady state is built up.
    文章建立了稳态条件下鱼雷热动力系统工作温度整体计算模型,通过算例验证了模型的正确性。
  6. Special version for high or low working temperature.
    特别版为高或低,工作温度。
  7. The new liquid crystals feature wide working temperature range, low voltage operation and high reliability.
    新型液晶的特点是:工作温度范围宽,工作电压低,可靠性高。
  8. The tapes and the cable shall have the same working temperature.
    隔火层包带的工作温度应和电缆的工作温度相同。
  9. The working temperature of the liquid must be measured every hour.
    液体的工作温度必须每小时测量一次。
  10. The key of the solution is to throttle after most liquid water is separated and to drop working temperature of the separator.
    解决问题的关键,是分离出大部分液态水后,再进行节流,并降低分离器工作温度。
  11. For example, the working temperature of some petroleum chemical equipments is very slow, and the working temperature of some internal-combustion engines or gas turbines is very high;
    实际的结构物或构件往往是在比较复杂的条件下工作的,例如,石油化工设备中有些机器的工作温度很低,而内燃机或燃气轮机的工作温度很高;
  12. Design and Simulation of Preserving Meter of Working Temperature of Hydraulic Pressure Electromagnetic Valve
    液压电磁阀工作温度记录仪的设计与仿真
  13. Run until the normal working temperature is reached.
    运转到温度达到正常的工作温度。
  14. Good performance in heatproof and cold resistant abilities with working temperature between-60 and180 ℃.
    产品具有较高的耐热性和耐寒性,其工作温度范围为-60~180℃。
  15. The core of VCM controller can stand working temperature of100C/ 212F.
    氯乙烯控制器的核心工作100C/212F经得起温度。
  16. In the modification, there should be a heater to provide the ink to work in its working temperature.
    在改装过程中,需要加装一个加热装置使得油墨在合适的温度下进行工作。
  17. When the transition layer is Copper T2 and Nickel N6 respectively, two kinds of working temperature above the eutectic temperature and below the eutectic temperature were chosen.
    以紫铜他、镍N6做过渡层时,选择了共晶温度以上和共晶温度以下两类加工温度;
  18. Discussion on the working temperature and quality grade of steel material
    关于钢材工作温度和质量等级的探讨
  19. The working temperature of sand cores for aluminum casting have been tested in the present work.
    对铝合金铸造用砂芯的工作温度进行了分析和测定。
  20. Attention must be paid to the working temperature of the machine.
    应当注意机器的工作温度。
  21. Offering heat in aclosed circulation, small heat loss, apparent effect of energy conservation, meeting the needs of a number of consumer equipment with different working temperature.
    闭路循环供热,热量损失小,节能效果显著,并可以满足不同使用温度的多个用热设备。
  22. Creep damage, crack initiation and fracture toughness at the material working temperature have been determined.
    探讨了30Cr2MoV材料在工作温度下的蠕变损伤及裂纹的启裂和高温断裂韧性特性。
  23. Its working temperature can reach 900 ℃ and its filtration efficiency is over 99%.
    其工作温度可达900℃过滤效率在99%以上,并具有透气性好,阻力损失小和反洗清灰效果好等特点。
  24. The sensitivity, selectivity and working temperature for some gases vary greatly with doping elements in the SnO_2 films.
    对SnO2薄膜的掺杂可大大改变气敏元件的灵敏度、选择性和工作温度。
  25. Several methods charactering upper limit working temperature of resin matrix composites are discussed.
    本文讨论了表征树脂基复合材料上限工作温度的几种方法。
  26. Research on Wear Resistance and Corrosion Resistance of Ni-P Coating under Different Working Temperature and Environment
    不同工作温度和环境下Ni-P合金镀层耐磨性及耐蚀性研究
  27. The practical technology to control the heat pipe working temperature was introduced based on the heat transfer principle.
    根据传热学原理,给出了控制热管工作温度的工程实用技术;
  28. Oxygen sensors fabricated by thick-film, thin-film, and lamination technology decreased total impedance leading to the decreases of working temperature and reducing response time.
    用厚膜、薄膜和叠片工艺制作的氧传感器,降低了总阻抗,从而降低了工作温度和缩短了响应时间。
  29. But the free silicon contained in RBSC restrains the working temperature of RBSC and reduces its mechanical properties.
    但是由于反应烧结碳化硅中含有一定量的游离硅,限制了反应烧结碳化硅的使用温度,降低了硬度等力学性能。